Home » Catalog » Carburetor Kits » Berg Weber Dual Carb Kits  
Product Categories
Apparel
American Hardware
Pistons and Cylinders
Flywheels and Clutches
Gaskets and Bearings
Cranks, Rods and Gland Nuts
Oiling System
Valve Train
Pulleys
Carburetion
   � 36/440 DRLA Venturi
   � Preventive Maintenance Tip About the Gas Tank Fuel Filter
   � Jet-A-Vator
   � Butterflies for Berg IDA
   � 32/34 PDSIT
   � Throttle shafts for Berg IDA
   � What Fuel Hose?
   � 44 IDF Venturi
   � 48 IDF Venturi
   � 40 IDF Venturi
   � Kadron/Solex Venturi
   � 45 Dellorto Venturi
   � 40 DCNF 112 schematic
   � Venturis for 44 DCNF
   � 45 DCOE Venturis
   � Solex P11 Venturi
   � Triple 40 IDA Venturi
   � Carburetor Linkages Fan Housing Mount
   - Linkages for 36hp Chinese dog house shroud
   - Linkages for VW fan housing mount.
   � Carb-to-Carb Mount
   � Center Pull
   � Stock Kadron Linkage
   � Carburetor Linkage Arms, Rods and Ball Joints
   � Linkage Arms - FYI
   � Carburetion for the VW Air Cooled Engines
   - Technical Information
   � Carbs Run Anything
   � Carburetors and Kits
   - Carburetors
   � Modify Your 48mm to 51mm
   - Carb Labor
   � The Berg IDA Carb
   - Berg IDA Carburetor Sizes
   � Carb Modifications
   � VW Factory Dual 32mm Solex Carb Kit
   � Air Cleaners
   � Polished Billet Aluminum New Linkage Pivot
   � Air Cleaner Vent Fitting
   � Carburetor Kits
   - Berg Weber Dual Carb Kits
   � Replacement Elements
   � Berg 48 IDA Velocity Stack
   � Dual 40mm Solex
   - Technical Information
   � 48IDA Venturis
   � Dual 40mm Solex Sets - FYI
   � 42 DCNF and Berg Specials
   - 42 DCNF
   � Carb Gasket Kits
   - Rebuild and Gasket kits
   � Dual 40mm Solex Carb Kits
   � Weber, Dellorto and Solex - FYI
   - Dual Gas Line
   � Berg/Weber Dual Carb Kits
   � But I Have To Have A Choke!
   - Technical Information
   � Jetting Information - FYI
   � What Fuel Pump to Use
   � I Use the Stock Pump
   � What Electric Pump to Use
   � Other Types of Regulators
   � Gas Line Size
   - Technical Information
   � Electric Fuel Pumps, Holley Pumps and Parts
   � Faucet Fuel Pumps
   � Vent Fitting
   � Replacement Elements, Oil and Cleaner
   � Berg 42 Velocity Stacks
   � Berg Billet Aluminum Velocity Stacks
   � Stock 48 IDA Weber Velocity Stack
   � Carb Covers for 48 IDA and Berg 58
   � Secondary Venturis
   - Berg Auxiliary Venturis
   � Venturis
   � Venturis for 40, 42 DCNF and Berg Special
   � Venturis for 48 IDA Weber
   � Venturis for IDA Berg Carbs
   � Jets - Main, Air and Idle
   - 42 Weber Type Air Jets
   - 42 Weber Type Idle Jets
   - 42 Weber Type Main Jets
   - 48 Weber Type Air Jets
   - 48 Weber Type Idle Jets
   - 48 Weber Type Main Jets
   - Solex Air Jets
   - Solex Idle Jets
   - Solex Main Jets
   � Ball Type Needle and Seat
   - Dellorto
   - Needle and Seats
   - Solex
   - Stock 48 IDA
   - Weber
   � Weber
   � Solex
   � Dellorto
   � Stock 48 IDA
   � Tall Jet Holder
   - Berg Tall IDA Type Emulsion Tube Holder
   � Emulsion Tubes for 40/44 IDF, 48 IDA/Berg IDA (sold per each)
   - Weber & Berg Emulsion Tubes
   � Customer Support
   � Carb Schematic Numbers to Weber and Berg Part Numbers
   - 42 DCNF & Berg Specials
   � 40/44/48 IDF
   � 48 IDA
   � Adjustable Accelerator Pump Ramp
   - Carburetor Parts
   � Banjo and Tee Fittings
   - Technical Tip
   � Carb Gasket Kits (for one carb)
   � Carb Rebuild Kits (per carb)
   � Float Height Gauge
   � Weber Parts
   - Additional Carburetor Parts
   � Gas Line Kits
   � Fuel Pump Block Off
   � Berg Super Strength Dual-Carb Manifold Sets
   - Manifolds for dual carb (Sold in pairs)

Programmable Fuel Injection
Electrical Parts
Cylinder Heads
Traction Bars and Mounts
Gear Sets, Tranny Parts, Suspension
5 Speed Kits
Special Tools, Tech Manuals
Exhaust Systems, Related Parts
Shifters and Related Parts
Wheelie Bars, Anti-shocker, Drag Fans
Welded Balance Cooling Fans
Type IV Tin Conversion
Shop Supplies
Cases and Related Parts
Labor Section
Factory Volkswagen Parts
Complete Engine Kits
Oils
Metric Hardware

Location: Home » Catalog » Carburetor Kits » Berg Weber Dual Carb Kits

Berg Weber Dual Carb Kits

    Berg 42 specials are the ultimate in driveability and power. Require ported heads such as GB 856 or better. GB 860 all the way up to GB 870 heads provide even greater gains in power with absolutely no loss in mileage, low end or driveability. GB 860-on require GB 932S or larger exhaust system, dependent upon combination.
    The Berg 42mm Weber Special carbs are redrilled and circuited to match specific VW engine applications. Each set is calibrated by our experts to work from idle to top RPM with the correct fuel flow rate and progression with all Berg parts. This ensures proper running throughout the RPM range without flat spots, lean, or rich conditions. Gives maximum performance with best fuel efficiency. Gives more available fuel/air for maximum cooling than any other Weber or Dellorto. Air cleaners are K & N wet element and come pre-oiled. Requires GB 622 distributor (and the tuning instructions that come with the distributor), GB 624 Gene Berg Igniter or a Stinger electronic ignition. If you already have a Bosch 009 request the Berg copyrighted instructions for GB 622 at the time you order your engine kit. Not designed for road race type driving or off-road. SW 25#
    Kits for sedan, bus, KG, and Type III.
    Note: Manifolds can be drilled and tapped for power brakes. Please specify if using on a bus that requires this.
    "Note 1: Weber has not made the 42 Berg special for years. Due to availability, Berg 42 kits are now supplied with reconditioned carbs that are in like new condition. All other parts are new. Note 2: These sets are only sold to our customers at the time they are buying a complete engine kit from us with a ""H"" at the end of the part number. No Exceptions."


     Product Name   Description   MSRP Price   Our Price+   Cash Price 
     GB 479U  Used 42mm sedan, KG, and bus kit. Originated by Gene Berg in 1970. Complete with two 515-CFM carbs, pair of GB 585A manifolds, GB 561 gas line kit with steel gas line "T", high quality fan housing mount linkage GB 450, GB 492 K & N element air cleaners, GB 500 velocity stacks and exclusive carburetion installation instructions. For 1700cc and larger engines. GB 860 or larger heads requires 1-1/2" or 1-5/8" competition exhaust. Carb comes with (GB 519M) 140 main, (GB 519A) 180 air and (GB 519J) 55 idle jets.   $0.00   $0.00   $0.00 
     GB 482U  Type III 42mm Weber kit. Comes with two 515-CFM carbs, GB 585 special Type III manifolds, gas line, air cleaners to fit under engine lid, special gas line "T" and same jetting as GB 479U. Instructions that are critical to the vehicle as well as the installation are provided. 1700cc or larger engine with GB 856 heads or better required. Works best with 78mm and longer stroke engines. We do not sell with complete linkage as the stock carburetor linkage can be modified with new rods from the pivot. If a linkage is needed see GB 457. Type III cars may require tripod mounts be replaced or shimmed up to clear air cleaners.   $0.00   $0.00   $0.00 
    Displaying 1 to 2 (of 2 products) Result Pages:  1 

     

     

    Quick Find
     
    Use keywords to find the product you are looking for.
    Advanced Search
    Information
    Business Hours
    Phone Service
    Placing Orders
    Shipping Policies
    Returns For Credit
    Warranty Policy
    Privacy Notice
    Disclaimers
    Contact Us

    Web design and hosting by Canvas Dreams LLC and California web design by Pearl Compass.

    Please contact us about errors or questions. We value your input!

    Any and all references to the company Volkswagen, or the VW name are strictly for reference only. The GENE BERG name and GENE BERG products are protected under trademark, copyright and patent law, any violations will be pursued. GENE BERG ENT. is not a part of any companies mentioned or linked to this website and any beliefs of those companies are not necessarily the beliefs of GENE BERG ENTERPRISES.

    Copyright ©2024 GENE BERG ENTERPRISES all rights reserved