Home » Catalog » Oiling System » Why we do not sell gauges » Technical Information  
Product Categories
Apparel
American Hardware
Pistons and Cylinders
Flywheels and Clutches
Gaskets and Bearings
Cranks, Rods and Gland Nuts
Oiling System
   � JayCee Sump Plate
   � Oil Additives Mandatory
   � Oil Filler and Breather
   � Oil Filler and Breather Box
   � Factory Generator Mount breather box
   - Berg Breather Boxes
   � Factory Alternator Mount breather box
   - Berg Breather Boxes
   � Race Breather Box
   � Valve Covers Vented for Breather Boxes
   - Vented Valve Covers
   � Oil Sumps
   - Technical Information
   � Standard Street Sump
   - Berg Oil Sumps
   � Ultra High-performance Street and Race Sump
   � 4 Quart Drag Race Sump
   � Sump Parts for Current and Early Berg Sumps
   - Sump Parts
   � Added Bearing Life
   - Technical Information
   � Extra Pickup Tubes
   � Added Capacity
   - FYI
   � Cooling
   - FYI
   � Oil Coolers
   - Technical Information
   � Oil Cooler Block Off Plate
   - Cooler Off Block
   � Why we do not sell gauges
   - Technical Information
   � How to know when your engine is hot.
   � How GB 227 Works
   � Berg Oil Temperature Dip Sticks
   - Oil Temperature Dip Sticks
   � Oil Pumps
   - Oil Pumps and Gaskets
   � 26mm Oil Pumps
   - For all dual oil pressure cases
   - For early single oil pressure cases
   � 30mm Oil Pumps
   - For all dual oil pressure cases
   � Oil Pump O'ring
   � Gaskets
   - Warning:
   � Technical Information
   � Oil Pressure Relief Covers
   - Use with or without FF
   � Full Flow Oil Pump Covers
   - Standard Full Flow Covers
   � Full Flow Oil Filtering
   - Technical Information
   � Tools Required to drill and tap a case for full flow
   � Achieve full oil flow from a plugged pump
   - FYI
   � Filter on Inlet Side
   - Warning
   � Full Flow Oil Filter Kits
   - Stainless Steel AN8 Hose Kits
   � Neoprene Hose Kits
   - Neoprene Hose Full Flow Kits
   - Substitute GB 239
   � Relief Valve Cover Option
   - Substitute Relief Valve Cover Option
   � System One Option
   � System 1 Filters
   � System 1 Spare Parts
   � Oberg Filter Screen
   - O Berg Filter Parts
   � Taps, Reamers & Drills
   - Taps and Reamers
   � Separate Full Flow System Parts and Fittings
   - Filters and Filter Adapters
   � Don't Have a Blow Out
   � PTFE Hose, Covered with Stainless Steel AN-8 Oil Hoses
   - PTFE Tubing
   - Stainless Steel Hoses
   � Custom Oil and Gas Hoses
   - AN-6 Gas Lines
   - AN-8 Gas Lines
   � Ordering Custom Oil or Gas Hoses
   - FYI
   � AN Fittings
   � Pipe Fittings
   � Hose
   - Hose per foot
   - Warning
   � "T" Fittings/Nipples
   - Nipples
   - Tees
   � Plugs for Oil Galleries
   - Hose Clamps
   - Plugs for Berg GBF Crankshafts
   - Standard tapered pipe plugs

Valve Train
Pulleys
Carburetion
Programmable Fuel Injection
Electrical Parts
Cylinder Heads
Traction Bars and Mounts
Gear Sets, Tranny Parts, Suspension
5 Speed Kits
Special Tools, Tech Manuals
Exhaust Systems, Related Parts
Shifters and Related Parts
Wheelie Bars, Anti-shocker, Drag Fans
Welded Balance Cooling Fans
Type IV Tin Conversion
Shop Supplies
Cases and Related Parts
Labor Section
Factory Volkswagen Parts
Complete Engine Kits
Oils
Metric Hardware

Location: Home » Catalog » Oiling System » Why we do not sell gauges » Technical Information

Technical Information

    Most Gauges Are "Horrible"
    I hear daily of engines being destroyed by people relying on gauges. I have run hundreds of accuracy tests on practically every inexpensive aftermarket gauge under $125 offered. Practically all read low in the 212 to 260 degree range by 40 to 50 degrees on oil temperature and head temperature gauges in the 250 to 550 degree reading range, again being low by as much as 250 or more degrees. I tested about twenty each of most brands such as VDO, Smith, Stewart Warner, Hawk, etc., and found none without these problems.
    Oil temperature gauge readings would be 212 to 220 degrees on the gauge when the true test temperature was 240 to 260 degrees. Head temperature gauges read 385 degrees with a true test temperature of 550 plus degrees. When head test temperatures were upped to 700 degrees, the reading of the gauge went up to 390 to 395 degrees. The price range of such gauges was from $60 to $125. I swapped gauges with senders and got different readings. I found nothing in that price range I would wish on my worst enemy. Not one I tested could ever be properly calibrated or relied on in any way for any valid information or even as a comparison from day to day on the air cooled VW. Yes, even the oil pressure gauges were just as bad.
    I found good accurate gauges range from about $250 to $350 and few people would buy them. What was needed was a device that gave the information required and was reasonably priced. That was the reason for the GB 227 in the first place. It is specifically made and calibrated to provide an accurate reading in the ranges of the VW air cooled engine. Originated by Hal Brown in 1972. Made in the USA.
    Note: If you must install an oil pressure gauge use GB 264-1/8 tee fitting and GB 265-1/8 pipe nipple to install the factory (Bosch VWA021-919-081B) light sending unit and the gauge together as the factory sender and light are over 100 times as fast to tell you if you run out of oil. Never use any sender that has the pressure and a light combination as they are extremely slow and you lose the rapid action that the factory light sender provides.
    Warning: If you want gauges as a decoration fine, but never rely on them. After all, if they provided reliable information I would be selling them to make a profit just like our competition.


    There are no products to list in this category.

     

     

    Quick Find
     
    Use keywords to find the product you are looking for.
    Advanced Search
    Information
    Business Hours
    Phone Service
    Placing Orders
    Shipping Policies
    Returns For Credit
    Warranty Policy
    Privacy Notice
    Disclaimers
    Contact Us

    Web design and hosting by Canvas Dreams LLC and California web design by Pearl Compass.

    Please contact us about errors or questions. We value your input!

    Any and all references to the company Volkswagen, or the VW name are strictly for reference only. The GENE BERG name and GENE BERG products are protected under trademark, copyright and patent law, any violations will be pursued. GENE BERG ENT. is not a part of any companies mentioned or linked to this website and any beliefs of those companies are not necessarily the beliefs of GENE BERG ENTERPRISES.

    Copyright ©2024 GENE BERG ENTERPRISES all rights reserved