Flycutter set, for use with 300 to 1,000 RPM good quality drill press. I suggest one with a friction stop on the column. If it does not have it you should order an extra stop collar (GB 700-4). 1/2" chuck and approx 7-1/2" height to chuck.
Complete as shown plus copyrighted instructions. Machines for up to 94mm p/c's.
Made in USA by us. SW 10#
Finished collar to be used as a pinch device on the shaft of the flycutter when the drill press does not have one. Helps control the rate of feed in cases so it does not catch and dig into the main bearing webs, or when a light cut is being made in the head bore. SW 2#